Products

Description

• Used indoors and outdoors on lined concrete and lined gas concrete surfaces, walls and ceilings where all kinds of rough plaster is applied.

• Provides a smooth surface.
• As it is white color, it can be used without paint.
• It has a positive effect on the overall appearance of the building.
• Reduces paint consumption.
• Saves time and labor.
• As it provides high adherence with the surface, provide an application that has less loss of fall back than black plaster.
• It provides high adherence and stability, does not sag.
• As it is a fabricated mortar, it provides quality continuity compared to black plaster.
• It is more resistant to outdoor conditions than black plaster.

a) Surface Preparation:
The surface should be dry, clean, sound and free of dust, oil, dirt or adhesion preventive materials should be cleaned from the surface and materials such as mortar and cement residues should be scraped. Repair of surface defects with a depth of more than 1 cm should be done with Lotti Repair Mortars 6-8 hours before application. In cases where structural repair mortar is required, Lotti Structural Repair Mortars should be preferred. Application surface should be moistened with water if necessary. After the surface cleaning, the surface should be primed with Lotti Multipurpose Primer as one coat and allowed to dry for 1-2 hours in order to increase the adhesion strength and balance the surface absorbency. Before applying the gas concrete surfaces, the water absorbency of the surface should be reduced by applying Lotti Multipurpose Primer. In order to increase the adhesion strength before the application on exposed concrete surfaces, the surface should be primed with Lotti Exposed Concrete Primer as a single coat and allowed to dry for a minimum of 3 hours.

b) Product Preparation:
35 kg Lotti Finish Plaster (Gray-White) is added into approximately 8-9 liters of clean water and mixed with a low-speed mixer so that no lumps remain. The prepared mortar is left to mature for 5-10 minutes and used by mixing again for 1-2 minutes. The mixture in the container should be consumed within 2-3 hours.

c) Application Method:
After the application is done with a steel trowel, the surface should be smoothed with a gauge. Application thickness should be between 2 mm and 7 mm. After the plaster is discharged its water, the surface should be clovered and the final corrections should be made with a damp sponge.