LottiFix zBlocker 1017

It is cement based, water and frost resistant, fiber added, gas concrete mortar with high performance, single component, high stability, that can be used outdoors, horizontal and vertical surfaces.

► Cement Based
► Indoors and Outdoors
► Water, Frost Resistant
► Easy Carding
► Time and Labor Saving
► Low Consumption

> Grey
> Public Works Pos No: 04.478


• For bonding gas concrete brick,
• For bonding pressed brick,
• For bonding pumice brick
• It has high adhesion strength.
• Easy to comb.
• Saves time and labor.

a) Surface Preparation:
Before application, gas concrete, pumice and pressed brick blocks should be checked and if there are wet, they should be allowed to dry. The gas concrete blocks are cut to the desired size with a gas concrete saw before the wall is built. In highly porous surfaces and hot air applications (if the surface temperature is above +25°C), the surface must be pre-wetted in a way to be moistened for the appropriate temperature. Thus, it will prevent the adhesive from losing its water quickly.

b) Product Preparation:
1 Bag (25 kg) 1017 Blocker is added slowly into 6-6,5 kg water and mixed for 5 minutes with 400-600 rpm mixer until it reaches a paste consistency. The prepared mixture is allowed to rest for 5 minutes, then mixed again and applied to the surface with an appropriate trowel. Proper chiseling is performed. For the smoothness of the wall surface, the smoothness of the horizontal and vertical joints can be ensured by using a rubber hammer, especially the first row should be very smooth. After the material is applied to the surface with a trowel and combed, it must be adhered according to the air temperature and the climatic conditions where the material is used. In such cases, the adhesive surface is pressed with finger and the adhesive surface is checked. If the material gets on the fingers, the bonding process is continued. Otherwise, the bonding process should be terminated and the dried adhesive material should be scraped off the surface and the new adhesive applied to the surface. All tools and equipment used should be cleaned with water before the mortar dries after application. The manufacturer’s instructions on the packaging must be observed before and during the application. Inspect Lotti Mill-Mixed Plaster to apply plaster to gas concrete, pumice block or hollow brick surfaces.

c) Application Method:
The prepared mortar is spread on the surface with a notched trowel or trowel with appropriate tooth size. The prepared mortar should be adhered on the gas concrete within 5 minutes. If this time has elapsed, the mortar should be scraped off the surface and the coatings. The laid bricks should be rammed from the top and side and made suitable to the rope and template. The amount of consumption given is theoretical and may vary depending on the application temperature, gas concrete brick size, surface and labor. We recommend sample application for consumption control.


There are no reviews yet.

Be the first to review “LottiFix zBlocker 1017”

Your email address will not be published. Required fields are marked *

    Lotti Building Chemicals which includes a total of 58 products under three main product categories, it is aimed to make a significant contribution to the process of brandization in Turkey as well as in abroad countries through offering of epoxy and polyurethane systems, ceramic adhesives, joint fillers and maintenance products, and outer façade insulation materials.


    Altıntepe Mh. E. Bagdat Cd. No:19/1 Istanbul/Turkey