Products

3002 İzo Coat

It is a single component, cement based, waterproofing mortar containing chemical additives providing water impermeability.

► Cement Based
► One Component
► Polymer Reinforced
► High Adhesion Strength
► Indoors and Outdoors
► Low Consumption

> Grey
> Public Works Pos No:

Description

• Suitable for use in basement walls, water tanks. It is used indoors and outdoors, horizontal and vertical surfaces.

• It provides the surface is resistant to water pressure coming from the positive side.
• Has high adhesion strength.

a) Surface Preparation:
It should be ensured that the cement-based surfaces in contact with water are solid, dry, carrier, dust-free and clean and at the same time in balance. The surface should be thoroughly cleaned of all kinds of oil, grease, rust and paraffin residues that will reduce the adherence and there should be no loose particles on the surface. Iron and wooden wedges on the surface should be removed and the gaps formed should be filled with Lotti Sealant Mortar or Lotti Structural Repair Mortar, and corners and edges should be chamfeed at least 4 cm radius. The application surface should be wet thoroughly and wait until it becomes wet/dry. If the coating material loses water immediately and becomes matt, it is understood that the surface is not sufficiently wetted or dries quickly. In such cases, when the air is hot or the materials are exposed to the wind, the mixing water of the material can only be increased by 10% for the first coat.

b) Product Preparation:
The water in appropriate amount is poured into the clean mixing vessel with a scale. 3002 İzo Coat is added slowly and mixed with a 400-600 rpm mixer for 3-5 minutes until a uniform and lump-free mixture is obtained. After resting for 3-5 minutes and mixing again for 30 seconds, the material is ready for use.

c) Application Method:
3002 İzo Coat waterproofing mortar is applied in two coats by brush. After the first coat is fully dry, the second coat is applied in a direction perpendicular to the first coat. To ensure continuity of insulation, joints of corners and edges should be chamfered with Lotti Repair Mortar. Where chamfering is not possible, Lotti Tape should be applied in areas with poor water impermeability, such as joints of edge, corner. In case the subsequent coat application is made 12 hours or more after the previous coat application, the surface should be moistened again before application.

Reviews

There are no reviews yet.

Be the first to review “3002 İzo Coat”

Your email address will not be published. Required fields are marked *

    Lotti Building Chemicals which includes a total of 58 products under three main product categories, it is aimed to make a significant contribution to the process of brandization in Turkey as well as in abroad countries through offering of epoxy and polyurethane systems, ceramic adhesives, joint fillers and maintenance products, and outer façade insulation materials.

    ADDRESS

    Altıntepe Mh. E. Bagdat Cd. No:19/1 Istanbul/Turkey

    PHONE

    +905357812191

    EMAIL

    info@lotti.com.tr

    Cart